I decided to go with the Progressive 460 rear shock, mainly due to the adjustable rebound damping on this unit. The Traxxion rear shock price was within a few dollars so I chose the adjustable one. Both units use a 1200 lb\/inch spring, while the OEM spring is 900 lb\/inch rate spring. Since I had just finished installing the front end, I already had the top shelter off but a few more pieces are removed and bolts loosened to be able to remove the gas tank. I had not looked forward to this part of the upgrade, but it turned out just fine. The tank finally came out but the ’06 wiring harness (or maybe just MY ’06 wiring harness) had a stiff bundle of wires exiting the relay panel over the rear of the tank and it took a bit of work to get the tank out.<\/p>\n
Once the tank is out removing the shock is easy. Loosening the right-side saddlebag and sliding it back a few inches made easy work of removing the actuator. My actuator began to labor at 5, and last year it began to labor at one, so I decided to refill the actuator while it was off the bike. I used Honda SS8 (10 weight) fork fluid for the refill. Reinstalling the shock and preload adjuster was pretty easy with everything out of the way.<\/p>\n
While the gas tank was off, I followed the advice of others and checked the coolant hose clamps to be sure they were tight. In my case they were, but I loosened a couple, twisted them to make future checks easier, and tightened them back down. I also checked the main ground lug for corrosion and found it to be tightly fastened and clean.<\/p>\n
Putting the gas tank back in required some wrestling with the wiring harness but since it came out it was definitely going back in. A little swearing and some silicone spray and the tank was back in and bolted in place and the wiring bundles returned to their proper location.<\/p>\n
Somehow, while it was off the bike, I managed to break one of the tabs on the top shelter – I have no idea when or how. I used abs cement and some fiberglass cloth to repair it, and it’s now stronger than new. The gas overflow tray is held onto the tank by plastic “fingers” and when I went to reinstall it every one was broken except one. Of course that delayed things until I could get a replacement from HDL. Got that and I will not remove that piece if the tank needs to come out again – I’ll just remove the hose from it. Another item to attend to while the top shelter was off – I redid the shielding on the cruise control. I used 8 thicknesses of heavy-duty foil and I hope this is better at blocking the 2-pitch noise from the cruise control actuator.<\/p>\n
OK, ready for final reassembly…<\/p>\n","protected":false},"excerpt":{"rendered":"
I decided to go with the Progressive 460 rear shock, mainly due to the adjustable rebound damping on this unit. The Traxxion rear shock price was within a few dollars so I chose the adjustable one. Both units use a 1200 lb\/inch spring, while the OEM spring is 900 lb\/inch rate spring. Since I had … <\/p>\n