The handlebars were too low and I couldn’t raise them any further. So, I ordered a taller quill stem from Harris Cyclery. But it was too tall so I cut off 3cm and it is close enough for now. To remove any more stem will require a different bolt as I’m out of threads on this one.<\/p>\n
It rides much better (as tested on the indoor trainer) and I ran through all positions on the front and rear derailleurs. Brakes are good, all bearings are good, time for a road test. The temps are in the mid-60s, and it’s dry. Time to go.<\/p>\n
Well, it was only 10 miles, but that was all it took. The bike rides great, makes all the expected mechanical noises – whirrs, clicks, shifting noises, etc. but no bad noises. The only obvious change necessary at this point is a mirror of some kind – more a survival aid than anything else.<\/p>\n
Tomorrow, weather permitting, I’ll go a different direction for another 10 miles or so.<\/p>\n","protected":false},"excerpt":{"rendered":"
The handlebars were too low and I couldn’t raise them any further. So, I ordered a taller quill stem from Harris Cyclery. But it was too tall so I cut off 3cm and it is close enough for now. To remove any more stem will require a different bolt as I’m out of threads on … <\/p>\n