Servicing the XTC mountain bike

Well, it’s time to take care of the Giant XTC mountain bike I bought a couple of years ago.  I’ve not ridden it much, but I decided it needs some attention since I plan to ride on the trails during the Bourbon and Tobacco Tour in April.  It would be pretty embarrassing for the ride organizer’s bike to break down, so I’m doing my best to prevent that from happening.

Actually, service probably isn’t the right word.  I’m replacing pretty much everything except the frame, fork, and wheels/hubs.  it will get a new headset, new disk brake calipers, rotors, and levers.  The drivetrain is switching from 3×9 to 1×11, with a Shimano XT-M8000 rear derailleur and a 11-40 rear cassette, and a new Shimano XT crankset with a 32 tooth wide-narrow chainring.  I’ll lose a little top speed, but my top speed isn’t all that fast anyway, and I thought this would be a good opportunity to try a 1×11.  The lowest gear will be a little lower, since the 32-40 gearing is lower than the previous 28-28.

All of the consumables will be replaced – tires, tubes, brake housing and cable, shift housing and cable, and grips.  New disk brake pads come with the new calipers, so technically they’re not being replaced, just superceded.

This bike requires some knowledge I’ve not needed before – disk brakes and 1×11 drivetrain (the derailleur has a clutch too).  The rest is fairly straightforward maintenance, so I’m not expecting the Spanish Inquisition.

But then, no one ever expects the Spanish Inquisition.

Leave a Reply